ГЕНЕРУВАННЯ СХЕМ РОЗКРОЮ ПИЛОМАТЕРІАЛІВ НА  БЕЗДЕФЕКТНІ ДІЛЯНКИ ЗА ДОПОМОГОЮ СПЕЦІАЛІЗОВАНОГО ПРО-ГРАМНОГО ЗАБЕЗПЕЧЕННЯ

Ярослав Мацишин; Володимир Маєвський; Дель Ріо

doi:10.36930/

Generation of lumber sawing plan into non-defective pieces by the use of specialized software

Authors

Ya.V. Matsyshyn Ukrainian National Forestry University
V.O. Mayevskyy Ukrainian National Forestry University https://orcid.org/0000-0001-5820-9454
A.M. Del Rio

DOI:

https://doi.org/10.36930/

Abstract

The specialized software for simulation of lumber sawing into non-defective pieces was developed. The suitability of the developed software usage for generation of lumber sawing plan into non-defective pieces was confirmed by the results of performed theoretical and experimental researches.

References

Ясинский В.С. Технология производства заготовок. – Л.: ЛЛТА, 1977. – 48 с.

Hruzik G. Technologiczna optymalizacja przerobu drewna na materiały tarte i półfabrykaty przeznaczeniowe. – Poznan: Wydawnictwo Akademii Rolniczej, 1993. – 92 s.

Clement C. Understanding rough mill yield through the analysis of the interaction between lumber characteristic and processing parameters // A Thesis Submitted to the Faculty of Purdue University by in Partial Fulfillment of the Requirements for the Degree of Doctor of Philosophy. – 2002. – 180 p.

Downloads

PDF (Ukrainian)

Published

2024-03-27

Issue

Vol. 37 No. 1 (2011): Forestry, Forest, Paper and Woodworking Industry

Section

Articles

How to Cite

Matsyshyn, Y., Mayevskyy, V., & Rio, D. (2024). Generation of lumber sawing plan into non-defective pieces by the use of specialized software. Forestry, Forest, Paper and Woodworking Industry, 37(1), 34-39. https://doi.org/10.36930/