METHODIC OF RESEARCH OF FACE RUNOUT OF CIRCULAR SAW IN THE PROCESS OF WOOD SAWING
DOI:
https://doi.org/10.36930/42164209Keywords:
Face runout, wood sawing, induction sensor, calibration, technological control.Abstract
The face runout of the saw is an important parameter of the equipment, which affects in particular the quality of the product and the durability of the tool. The article describes a well-developed technique for researching the face runout of a saw, which differs by the used sensor, the simplified procedure of its calibration and the method of processing the received signals. The use of computer technology ensures a wide range of settings, displaying results in a convenient format, enables automation of signal processing.
References
Sanyov V.Y. Obrabotka drevesyny kruhlymy pylamy [Wood treatment with round saws]. – M.: Forest industry, 1980. – 232 p.
Stahiev Yu.M. Rabotosposobnost ploskykh kruhlykh pyl [The working capacity of flat round dust]. – M.: Forest industry, 1989. – 384 p.
Polischuk Ye.S., Dorozovets MM, Yatsuk V.O., etc. Metrolohiya ta vymiryuvalna tekhnika [Metrology and measuring technique: a textbook]. – Lviv: Beskid Beat, 2003. – 544 p.
Zhuk A.Ya., Zhelyabin N.K, Malyshev G.P. Osnovy naukovykh doslidzhen v sferi praktychnoyi mekhaniky [Fundamentals of scientific research in the field of practical mechanics]. – K.: Condor Publishing House, 2012. – 224 p.
Downloads
Published
Issue
Section
How to Cite
