Трансформація енергетичної бази Польщі. Енергозбереження та використання відновлюваних джерел енергії

Тарас Бондаренко

doi:10.36930/

Authors

T.V. Bondarenko

DOI:

https://doi.org/10.36930/

Keywords:

energy efficiency, renewable energy sources, biomass, energy audit.

Abstract

The article is about the energy transformation of the Polish economy over the last 25 years. The basic steps of transformation, mechanisms of white certificates, energy audits, energy conservation processes in the industry. Also, the article focuses on the use of renewable energy sources in Poland, such as biomass, hydropower engineering, wind power engineering, etc., as well as mechanisms for financing projects in the field

References

Slupik, T., Penar, J. (2010) Enerhoaudyt v yakosti dopomohy dlya efektyvnoho vyrobnytstva ta vykorystannya enerhiyi [Energy audit as an aid to efficient energy production and use]. Heat and Professional Energy, 2010(4), 58-61 (in Polish).

Tamaka, A. (2010) Dosvid yevropeyskykh krayin u vprovadzhenni mekhanizmiv pidtrymky enerhetychnoyi efektyvnosti [The experience of European countries in the implementation of mechanisms to support energy efficiency]. New Energy, 2010(3), 25-29 (in Polish).

Berbeka, K. (2011) Naslidky vvedennya bilykh sertyfikativ yak instrumentu polipshennya enerhetychnoyi efektyvnosti [The consequences of the introduction of white certificates as a tool for improving energy effi-ciency]. Warsaw: Ardruk (in Polish).

Kassenberg, A., Sobolewski, M. (2009) Klimatychna polityka Polshchi - vyklyk XXI viku [Climate policy of Poland - Challenge of XXI century]. Warsaw (in Polish).

Warsaw: Institute of Applied Science (2013) Podorozh v nyzkovuhletseve maybutnye [Low-emission fu-ture]. Warsaw: Institute of Applied Science (in Polish).

Gayda S.V., Maksymiv V.M., Tunytsya T.Yu. (2008) Elaboration of post-consumer wood classifier // Forestry, Forest, Paper and Woodworking Industry, 34:55-68. (in Ukrainian).

Gayda S.V., Maksymiv V.M. (2007) Analysis, features, problems and experience of the use of addi-tional resources of raw material – wastes and of used wood // Forestry, Forest, Paper and Woodworking Indus-try, 33:63-73. (in Ukrainian).

Gayda S.V., Maksymiv V.M. (2010) From recycled post-consumer wood towards prime quality parti-cleboard // Forestry, Forest, Paper and Woodworking Industry, 36:57-77.

Gayda S.V. (2007) Research of concentration of operations is in modern furniture Productsion // For-estry, Forest, Paper and Woodworking Industry, 33:73-79. (in Ukrainian).

Gayda S.V. (2007) А problem of wood raw material is in Europe and Ukraine // Forestry, Forest, Paper and Woodworking Industry, 33:55-63. (in Ukrainian).

Gayda S.V. (2009) Potential of post-consumer recovered wood and possible ways of it using in Ukraine // Forestry, Forest, Paper and Woodworking Industry, 35:63-83.

Gayda S.V. (2008) Chemical compound and degree of its contamination as the basis to systematization of post-consumer wood / Forestry, Forest, Paper and Woodworking Industry, 34:68-79. (in Ukrainian).

Gayda S.V. (2010) A comparative analysis of physical-and mechanical parameters of variously-designed Glued Boards made of post-consumer Recovered Wood / Forestry, Forest, Paper and Woodworking Industry, 36:81-91.

Gayda S.V. (2011) Recovered wood is additional resource of raw material // Forestry, Forest, Paper and Woodworking Industry, 37.1:238-244. (in Ukrainian).

Gayda S.V. (2012) Production techniques and properties of fuel pellets produced from post-consumer wood // Forestry, Forest, Paper and Woodworking Industry, 38: 112-150.

Gayda S.V. (2009) The effective use of post-consumer wood is basis for diminishing of СО2-emission // Scientific Herald, 19.14:72-89. (in Ukrainian).

Gayda, S. (2011) The investigation of physical and mechanical properties of wood particleboards made from post-consumer wood // Forestry, Forest, Paper and Woodworking Industry, 37.2:95-110.

Gayda S.V., Voronovich V.V. (2011) Investigation of the features of bending of post-consumer wood // Proceedings of the Conference, Mari State University, 190-192 (in Russian).

Gayda, S., Dyak, T. (2011) The analysis of economic efficiency of post-consumer wood use for parti-cleboard manufacture for LLC Swisspan Limited // Forestry, Forest, Paper and Woodworking Industry, 37.2:129-136.

Gayda, S. (2013) Technologies and recommendations on the utilization of post-consumer wood in woodworking industry. Forestry, Forest, Paper and Woodworking Industry, 39.1:48-67.

Gayda S.V., Voronovich V.V. (2011) Comparative analysis of bending particularities for various post-consumer wood species and age categories // Forestry, Forest, Paper and Woodworking Industry, 37.1:84-88. (in Ukrainian).

Gayda, S. (2011) Recycled of post-consumer wood is for the production of particleboard in Ukraine. Proceedings of the XXI International symposium Adhesives in Woodworking Industry (Slovakia, Zvolen Juve 29 – July 01. 2012). TU Zvolen, 108-121.

Gayda, S. (2013) The technological solutions for recycling of post-consumer wood. Proceedings of I In-ternational Interdisciplinary Scientific Conference Formation of stable outlook as the basis of sustainable de-velopment (Ukraine, Lviv, 14-16 March 2013) UNFU: Lviv, 5-11.

Gayda, S. (2013) Techniques for utilization of post-consumer wood in the production of fuel pellets and briquettes. Proceedings of the XXI International symposium Adhesives in Woodworking Industry (Slo-vakia, Zvolen Juve 23-26. 2013). TU Zvolen, 119-130.

Gayda, S. (2014) The theoretical rationale for the approach on the prediction the strength of parti-cleboard from recycled wood. Collection of scientific works, BGITA, 38, 212-216.

Gayda S.V. (2013) Resource-saving technologies of recycling of post-consumer wood]. Scientific Bulle-tin of NULES of Ukraine: Technology and Energy of agroindustrial complex 185(2):271-280, (in Ukrainian).

Gayda S.V. (2013) Bases of secondary wood resources classifier formation. Scientific Works of the For-estry Academy of Sciences of Ukraine 11:208-215 (in Ukrainian).